319
Appendix A
2.
Click the
OK
Button. The following kind of diagram will be displayed.
3.
Repeat the Connections setting procedure until all of the connections have been set.
Note
After completing the settings, always click the
OK
Button before closing the Edit Device Parameters Dia-
log Box and performing another operation. If the
Cancel
Button is clicked and the dialog box is closed,
the new settings will be discarded.
4.
If the tag set’s size is changed in either the originator or target after the connection was set, the size will not
match the other node and a parameter data mismatch will occur. In this case, if the connection settings have
been changed, be sure to check the connections. (Refer to
7-2-13 Checking Connections
in the
SYSMAC
CS and CJ Series EtherNet/IP Units Operation Manual
(Cat. No. W465).)
Indicates the IP address of the
originator where the connection
was set.
Summary of Contents for DeviceNet Safety
