25 INSTALLATION MANUAL /PAGE 1 OF 2 / 100522
WWW.ZETR.COM.AU / [email protected]
TO O LS R EQ U I R E D
I N T H E B OX
25-4P-DACC-BS7
PH2
DRIVER
- The device must be installed
according to the instructions
outlined in this document.
- The device must be installed
with care, by a licensed electrician/
tradesman
- Installation must comply with
Australian and New Zealand
standards ASNZ3000.
- Pay attention to the wiring
diagrams and specifications related
to the installation.
- Do not use this product for any
other purpose than specified in this
manual.
- If any part of the device is
damaged prior to installation it
must be replaced/repaired by the
manufacturer or licensed service
agent prior to installation
- The device must not be modified,
or force fit. Any modification or
non-compliant installation will
jeopardise system safety and/
or result in equipment damage or
malfunction.
- ZETR forfeits any liability and
warranty for any modified product
and/or installation
THE SAFETY OF THE DEVICE IS GUARANTEED WHEN THE INSTRUCTIONS
AND USE ARE IN-LINE WITH THOSE OUTLINED. IT IS RECOMMENDED
THAT THIS MANUAL IS STORED SAFELY AND REFERRED TO
THROUGHOUT THE LIFE OF THE DEVICE.
WHEN CARRYING OUT INSTALLATION OR MAINTENANCE, IT IS ESSENTIAL
TO ISOLATE SUPPLY AND FOLLOW THE CORRECT LOCK OUT AND TAG
PROCEDURE AT THE POINT OF SUPPLY BEFORE ACCESSING THE DEVICE.
ELECTRIC SHOCK, EXPLOSION OR ARC FLASH HAZARD
Hazardous voltage and electrical current may be present at the wire leads of
this product even when the device is switched off.
WA R N I N G
DA N G E R
AT T E N T I O N
25 POWER & DATA SYSTEM
PH1
DRIVER
18-40MM
SUBSTRATE
[NOT INCLUDED]
UNDERCARRIAGE
MECHANISM
GRID
LEVELING
FASTENER
FACEPLATE
