90
Editing Parameters
Section 4-1
4-1
Editing Parameters
Device parameters can be edited using any of the following methods.
1.
Double-click a device icon.
2.
Select a device, and then select
Device - Parameter - Edit
from the menu
bar.
3.
Select a device, and then click the
Edit Parameter
Button on the toolbar.
4.
Right-click the device and select
Parameter
- Edit
.
5.
Select the device, and then select
Device - Parameter - Wizard
.
Note
With Network Configurator version 2.0
@
or higher, basic parameters can be
set using a wizard. Using this parameter will reduce errors in the parameter
settings.
4-1-1
Setting Parameters Using the Wizard
With Configurator Ver. 2.0
@
or higher, I/O parameters for DST1-series Con-
trollers can be set using a wizard. This section explains the procedure.
1.
Select a DST1-series Controller, and then select
Device - Parameter -
Wizard
. The following window will be displayed.
If there are no output terminals (DST1-ID12SL-1), the window for setting
input terminals will be displayed.
2.
In the window above, specify the type of device to be connected to each
terminal. The following types can be specified.
Type
Description
2 Safety Relays with welding check
(See note 1.)
Specify to connect to two Safety Relay
outputs (with welding check for each).
2 Safety Relays w/o welding check
(See note 1.)
Specify to connect to two Safety Relay
outputs (with no welding check).
1 Safety Relay with welding check
Specify to connect to one Safety Relay
output (with welding check).
1 Safety Relay w/o welding check
Specify to connect to one Safety Relay
output (with no welding check).
Other 2 Safety Outputs w/o welding
check (See note 1.)
Specify to connect to two outputs without
welding check.
Other Safety Output w/o welding check
Specify to connect to one output without
welding check.
Door SW Lock
Specify to connect to an electromagnetic
door switch.
Summary of Contents for DeviceNet Safety
