Omron DeviceNet Safety, System Configuration Manual

Page: 93 / 376

59
Creating a Virtual Network Section 3-4
• Select the network port to be connected, and then click the OK Button.
Uploading will start.
• After uploading has been completed, the following dialog box will be dis-
played if there is a NE1A-SCPU01-EIP, NE1A-SCPU02-EIP, or NE1A-
EDR01 in the network.
• The following dialog box will be displayed if the Yes Button is clicked here.
• Uploading for the target network will start if the Yes Button is clicked here.
If there is another device that must be added after the upload has completed,
add the device following the same procedure as in
Adding Devices from the
Hardware List , above.
IMPORTANT If there is a CS/CJ-series DeviceNet Unit in the network, disable the master
function of the CS/CJ-series DeviceNet Unit, or disable I/O communications
from the DeviceNet Unit monitor window, and then do the upload. If I/O com-
munications are enabled, uploading the device parameters may fail.
Note • When uploading the network configuration from a network, it can be
uploaded as the configuration or the current network or as a new network.
• When data is uploaded as a new network, the virtual network information
that was displayed until will be deleted. If the previous virtual network
information is required, save the data before the uploading the network.