Omron DeviceNet Safety, System Configuration Manual

Page: 132 / 376

98
Editing Parameters Section 4-1
4-1-5 Test Output Parameter Groups
This section describes parameters in the test output groups.
The test output parameters are grouped by terminal number.
Item Settings Description Default
S Test Output Mode Not used. The corresponding test output is not used. Not used.
Standard Output Specifies connecting to the input for a muting
lamp or PLC. Used as a monitor output.
Pulse Test Output Specifies connecting a device with a contact
output in combination with the safety input.
Power Supply Output Specifies connecting to the power supply ter-
minal of a safety sensor.
The voltages supplied to the I/O power from
the test output are output.
Muting Lamp Output
(Setting supported only
for T3 terminal.)
Specifies a muting lamp output.
When the output is ON, disconnection of the
muting lamp can be detected.
Fault Action Clear off Sets the output state of the test output when
a communications error occurs.
This parameter is enabled when the Test
Output Channel Mode is set to
Standard
Output or Muting Lamp Output .
Clear off
Hold last data
I/O Comment 32 characters max. Sets an I/O comment for the test output. The
I/O comment set here is used as the I/O tag
in the Logic Editor. None
Maintenance Counter
Mode Choice Time (total ON time) Sets the operating mode for the mainte-
nance counter. Time
Count (operation count)
Threshold Mainte-
nance Counter 0 to 4,294,967,295
hours Sets the threshold value for the maintenance
counter. 0