146
Local I/O Settings
Section 5-5
Dual Channel Safety Input Mode
Set the Dual Channel Safety Input Mode and the discrepancy time. The com-
binations that can be used in Dual Channel Mode are pre-defined.
The discrepancy time can be set between 0 and 65,530 ms in 10-ms incre-
ments.
5-5-3
Setting Test Outputs
Click the
Local IN/Test Output
Tab and then
Test Output
Tab in the window
to set the test outputs.
Error Latch Time
The test output is used in combination with a safety input. The same error
latch time setting is thus used for all safety inputs. Refer to
Error Latch Time
in
5-5-2 Setting Safety Inputs
.
Channel Mode
Description
Single Channel
Specifies using Single Channel Mode.
If
Single Channel
is selected, the Safety Input Terminal to be paired in the Dual
Channel setting will also be set to Single Channel Mode.
Dual Channel Equivalent
Specifies using the Dual Channel Equivalent Mode with a paired Safety Input Ter-
minal.
Dual Channel Complementary
Specifies using the Dual Channel Complementary Mode with a paired Safety Input
Terminal.
Summary of Contents for DeviceNet Safety
