![background image](http://html1.mh-extra.com/html/omron/devicenet-safety/devicenet-safety_system-configuration-manual_743566209.webp)
175
Programming
Section 6-3
4.
Select the name of the jump source and click the
OK
Button.
The jump address will be displayed as follows:
Note
Double-click a jump address to change the display to the corresponding jump
address.
Function Block I/O Information
The input and output descriptions for a function block are displayed when the
mouse cursor is placed on the corresponding I/O point on the screen.
Editing Function Block Parameters
To edit the parameters of a function block, use any of the following methods to
display the Parameter Edit Window.
1.
Double-click the function block.
2.
Select the function block and then select
Edit - Properties
from the menu
bar.
3.
Right-click the function block and the select
Edit
from the pop-up menu.
4.
Select the function block and then click
Property
on the toolbar.
Note
The parameters that can be edited depend on the function block. For details,
refer to the
Safety Network Controller Operation Manual
(Z906).
Summary of Contents for DeviceNet Safety
