![background image](http://html1.mh-extra.com/html/omron/devicenet-safety/devicenet-safety_system-configuration-manual_743566144.webp)
110
Editing Parameters for Logic Terminals (DST1-XD0808SL-1)
Section 4-2
(2) Output from the Logic
The result of the internal logic is output to the local output terminal. The
output condition can be selected from the following list. (The condition
depends on the input settings. For example, if IN0 and IN1 are used as
a single input, IN0/1 becomes IN0, IN1.)
(3) Auxiliary Output
The safety output is used as an auxiliary output. Select the data to out-
put as the auxiliary output. The data can be selected from the following.
Setting the Welding Check (EDM)
1,2,3...
1.
Click the selection button shown in the following figure.
OUT0
Output the same value as OUT0.
OUT0 (NOT)
Output the inverted value of OUT0.
OUT2
Output the same value as OUT2.
OUT2 (NOT)
Output the inverted value of OUT2.
OUT4
Output the same value as OUT4.
OUT4 (NOT)
Output the inverted value of OUT4.
OUT6
Output the same value as OUT6.
OUT6 (NOT)
Output the inverted value of OUT6.
Reset Required Indication Outputs a signal flashing at 1 Hz to prompt for a
reset input. The signal is output when more than
one terminal can be reset from all the safety input
terminal reset operations.
RUN Status
Outputs the operating mode.
0: Other than RUN
1: RUN
Normal Status
Outputs normal status.
0: Error
1: Normal
Summary of Contents for DeviceNet Safety
