135
Standard Slave Settings
Section 5-3
You can add, change, and delete I/O assemblies for a Standard Slave in this
window. Input assemblies and output assemblies can be registered for each
standard connection.
• To add an I/O assembly, click the
New
Button. The I/O Assembly Setting
Window will be displayed. Refer to
5-3-3 Setting Assembly Data
to define
the I/O assembly data.
• To change the I/O assembly data, select the I/O assembly you want to
change and click the
Edit
Button. The I/O Assembly Setting Window will
be displayed. Refer to
5-3-3 Setting Assembly Data
to define the I/O
assembly data.
• To delete the I/O assembly, select the I/O assembly you want to delete
and click the
Delete
Button.
5-3-2
Setting Slave Input Data in Idle State
Set to hold or clear the last data for an input assembly that the NE1A-series
Controller transmits to the Standard Master in either of the following condi-
tions:
• When changing the NE1A-series Controller from the RUN state to the
IDLE state.
• When detecting an error, such as a communications error in a safety
chain, that sets the data to an I/O tag in an input assembly.
5-3-3
Setting Assembly Data
This section describes how to define I/O assembly data.
I/O Type
Select the connection type to use for the I/O assembly. Input assemblies and
output assemblies can be registered for each connection. Output assembles
cannot be registered, however, when
Bit-Strobe
is selected as the connection
type, because the data cannot be output by the Standard Master.
Summary of Contents for DeviceNet Safety
