134
Standard Slave Settings
Section 5-3
5-3
Standard Slave Settings
Clicking the
Slave I/O
Tab displays the window for setting a Standard Slave
I/O assembly that is necessary for operating the NE1A-series Controller as a
Standard Slave. The I/O assembly set here is displayed and can be selected
in the Connection Setting Window of, for example, the DeviceNet Unit for a
CS/CJ-series PLC that is a Standard Master.
The I/O tags defined in the I/O assembly can be used in the Logic Editor.
Note
When the NE1A-series Controller is not used as a Standard Slave, it is
not necessary to set the parameters in this window.
5-3-1
Registering I/O Assemblies for Standard Slaves
Register the I/O assemblies for the Standard Slave to be used when the
NE1A-series Controller functions as a Standard Slave.
The following information is displayed in this window.
Item
Information Displayed
Name
The registered I/O assembly name (
icon) and I/O tags name defined in the assembly
(
icon) are displayed.
Type
The input/output type for the I/O assembly and data types for the I/O tags are displayed.
Size
I/O assembly size and the sizes of I/O tags are displayed.
Summary of Contents for DeviceNet Safety
