Omron DeviceNet Safety, System Configuration Manual

Page: 120 / 376

86
Device Reset and Status Change Section 3-10
3-10-3 Reset Types and Device Status
Resetting may not be supported for some types of reset and device status.
3-10-4 Changing Device Status
Changing the device status is not supported by all devices.
The NE1A-series Controller can switch between IDLE mode and RUN mode.
For details on NE1A-series Controller modes, refer to the
Safety Network
Controller Operation Manual (Z906) .
For DST1-series Safety I/O Terminals, there is no need to change modes.
Change the device mode using either of the following methods. This function
is enabled only when the Network Configurator is online.
With Network Configurator Ver. 2.0 @ or higher, modes can be changed all at
once by selecting multiple devices.
1. Select a device, and then select Device - Change Mode followed by the
desired mode.
2. Select a device, and then right-click the device and select Change Mode
followed by the desired mode.
Next, the password input window for the device will be displayed. Enter the
password for the selected devices and click the
OK Button.
IMPORTANT The mode cannot be changed in the EtherNet/IP Network Window for the
NE1A-SCPU01-EIP or NE1A-SCPU02-EIP. Change the mode in the
DeviceNet Network Window.
Reset type Device status
Safety connec-
tion being estab-
lished and
configuration
locked. Safety connec-
tion being estab-
lished and
configuration
locked. Safety connec-
tion not estab-
lished and
configuration
locked. Safety connec-
tion not estab-
lished and
configuration
locked.
Emulate cycling
power Unable to reset. Unable to reset. Able to reset. Able to reset.
Return to the out-
of-box configura-
tion, and then
emulate cycling
power. Unable to reset. Unable to reset. Unable to reset. Able to reset.
Return informa-
tion except for
specified parame-
ters to the out-of-
box configuration,
and then emulate
cycling power. Unable to reset. Unable to reset. Unable to reset. Able to reset.