Omron DeviceNet Safety, System Configuration Manual

Page: 141 / 376

107
Editing Parameters for Logic Terminals (DST1-XD0808SL-1) Section 4-2
(1) No Reset Signal
Reset signal is not specified.
(2) Reset Signal
A reset signal is specified. The following dialog box will be displayed
and the reset signal can be specified.
• Inputs that can be set as the reset signal are as follows.
Remote I/O Signal Low-High-Low
Remote I/O Signal Rising Edge
IN6 Low-High-Low
IN6 Rising Edge
IN7 Low-High-Low
IN7 Rising Edge
• The following dialog box will be displayed when setting is completed.
• If modification is required after completing the settings, click the Dis-
able Input or Reset Button to enable making changes.
3. When the settings have been completed, click the Next Button.
The Safety Logic Wizard - Output Dialog Box (the dialog box to edit safety
logic for outputs) will be displayed.
4-2-4 Editing Safety Logic: Outputs
Click the Next Button in the Configuration Result Dialog Box in step 3 in 4-2-3
Editing Safety Logic: Inputs to display the following Safety Logic Wizard - Out-
put Dialog Box (the dialog box to edit safety logic for output).
You can set the output conditions, welding check (EDM), and the terminal
modes in this dialog box.
▲
Displays settings.