242
Basic Online Operations
Section 9-5
9-5
Basic Online Operations
This section describes the procedure for online operations. Make sure that
you read through the material before performing online operations.
9-5-1
Connecting the Maintenance Tool
The Maintenance Tool can be used by connecting it to the USB port on an
NE0A/NE1A-series Controller.
When the Maintenance Tool is connected to the USB port of an NE0A/NE1A-
series Controller, the following Main Window will be displayed. The device sta-
tus will be displayed in the Main Window.
Note
Click the
Re-Connect
Button if the USB cable is disconnected and connected
to the USB port of another NE0A/NE1A-series Controller after the Mainte-
nance Tool has been connected online.
Device Status
The device status is indicated by the following colors.
Re-connect
Button
Device status
Click the Re-Connect Button to connect the
Maintenance Tool to the USB port of a
difference NE0A/NE1A-series Controller.
Color
Status
Blue
RUN
Green
IDLE
Yellow
Warning
Red
Alarm
Gray with white outline
Disconnected
Gray with green outline
Default status (not configured)
Summary of Contents for DeviceNet Safety
