171
Programming
Section 6-3
Using I/O Tags
I/O tags can be used for the following when programming.
• Local terminals on the local Safety Network Controller (I/O tags set in
advance)
• Local terminals for Safety I/O Terminals registered as communications
partners (I/O tags set beforehand).
• Local terminals on the local Safety Network Controller (Safety Slaves) for
accessing another Safety Master on the network (user-defined I/O tags
for assembly data settings)
• Local terminals on the local Safety Network Controller (Standard Slaves)
for accessing another Standard Master on the network (user-defined I/O
tags for assembly data settings)
The following useful functions for I/O tags are supported in the version
upgrade.
• The I/O tags used in the program are highlighted in the Object List, as
shown in the following diagram.
• I/O settings are displayed with symbols with the I/O tags in the Object List.
I/O settings data is displayed with symbols.
Summary of Contents for DeviceNet Safety
