50
Connecting to the Network
Section 3-3
In the first network connection, a network search is performed automatical-
ly with this dialog box displayed. Wait until the search has been performed
for all addresses. After the search, the networks that can be connected will
be displayed.
Automatic searching for networks will not be performed the second time or
after.
5.
Select the network to connect to, and click the
OK
Button.
If is online connection is made normally,
On-line
will be displayed in the
status bar at the bottom of the window.
3-3-3
Network Connection via Ethernet
This section describes the procedures for connecting to the network via Ether-
net (enabled only when using the NE1A-SCPU01-EIP, NE1A-SCPU02-EIP, or
NE1A-EDR01).
1.
Select
Option
-
Select Interface
.
2.
Select
Network
-
Connect
.
The Select Interface Dialog Box will be displayed.
3.
Click the
OK
Button.
The Select Connect Network Port Dialog Box will be displayed.
Summary of Contents for DeviceNet Safety
