Omron DeviceNet Safety, System Configuration Manual

Page: 314 / 376

280
Appendix A
IMPORTANT Always select the peripheral bus (ToolBus) interface when making a serial connection through
the CS1W-CN226/626 or the XW2Z-200S-CV/500S-CV Connecting Cable to a CS-series PLC
with the CS1W-DRM21(-V1) mounted to the CPU Rack. A connection will not be possible if the
Host Link interface is selected.
Note (1)
For information on the FINS node address, refer to the
CS/CJ-series DeviceNet Unit Operation Manual
(W380).
(2)
When
Host link is selected, it may take several minutes to download from the network. It is recom-
mended to select the Peripheral Bus (ToolBus) for the serial connection.
Baud Rate Set the baud rate for the serial communications port on the
CS/CJ-series PLC.
• 9,600, 19,200, 38,400, or 115,200 bit/s.
Note The baud rates that can be selected for the peripheral
bus (ToolBus) and Host Link are different. For details,
refer to the
CS/CJ Series Operation Manual .
Data Length Set the data length for the serial communications port on
the CS/CJ-series PLC. This setting is required only when
using the Host Link interface.
• 7 or 8 bits
Parity Set the parity for the serial communications port on the CS/
CJ-series PLC. This setting is required only when using the
Host Link interface.
• None, even, or odd
Stop Bits Set the number of stop bits for the serial communications
port on the CS/CJ-series PLC. This setting is required only
when using the Host Link interface.
• 1 or 2 bits
CS-series
DeviceNet Unit
The Host Link interface cannot be used when
using theCS1W-CN226/626 or the
XW2Z-200S-CV/500S-CV Connecting Cable.
Use the peripheral bus interface.
DeviceNet network
Network Configurator
WS02-CFDC1-J