213
Maintenance Functions (Unit Version 1.0 or Later)
Section 7-2
Setting the Total ON Time Alarm Threshold with the Network Configurator
The maintenance mode (Maintenance Counter Mode Choice) and alarm
threshold (Threshold Maintenance Counter) can be set for each local input,
test output, and local output terminal.
If the alarm threshold (Threshold Maintenance Counter) is set to 0, the Con-
troller will not compare the count or time PV to the alarm threshold SV.
Monitoring the Total ON Time from the Network Configurator
Any of the following methods can be used to monitor the total ON time in the
local inputs, test outputs, or local outputs.
1.
Select the device and select
Device – Maintenance information
from the
menu bar.
2.
Select the device and click the toolbar’s
Maintenance
Button.
3.
Select the device, right-click that device, and select
Maintenance infor-
mation
from the popup menu.
4.
Select the device, select
Device – Monitor
from the menu bar, and click
the
Maintenance
Tab in the displayed window.
5.
Select the device, click the toolbar’s
Device Monitor
Button, and click the
Maintenance
Tab in the displayed window.
6.
Select the device, right-click that device, select
Monitor
from the popup
menu, and click the
Maintenance
Tab in the displayed window.
Summary of Contents for DeviceNet Safety
