Omron DeviceNet Safety, System Configuration Manual

Page: 150 / 376

116
Safety Connection Settings Section 5-1
5-1 Safety Connection Settings
Open the Edit Device Parameter Window of the NE1A-series Controller and
click the
Safety Connections Tab to display the Safety Connection Setting
Window. In this window, you can register the Safety Slaves, such as the
DST1-series Safety I/O Terminals, that perform the safety communications
and set the communications parameters.
Note Setting parameters in this window is not necessary when the NE1A-series
Controller is used with DeviceNet communications disabled (standalone).
5-1-1 Registering Safety Slaves
Use the following procedure to register Safety Slaves as communications des-
tinations.
1. Unregistered devices are listed in the upper pane, and registered devices
are listed in the lower pane.
2. Select a Safety Slave to register in the Unregister Device List and click the
Button.
3. The Safety Slave selected in step 2 will be registered.
If the
Auto Allocation Check Box is selected at this point, the default con-
nections and the parameters are will be automatically allocated as shown
in the following figure.