196
Programming
Section 6-3
6-3-8
Updating the Program
If the I/O tags of the Safety Slaves that configure the NE1A-series Controller’s
local I/O and connections are changed (e.g., by adding or deleting I/O tags),
the user must start the Logic Editor and check the program.
If the user downloads the parameters to the NE1A-series Controller without
starting the Logic Editor, a download error will occur in the Logic Editor
because of data inconsistency. If this error occurs, start the Logic Editor and
check the program, making any required modifications.
6-3-9
Monitoring the Program
The I/O tag values and signal states of connections with function blocks can
be monitored online in the Logic Editor Window. Make sure that the Network
Configurator is connected to the network and that the NE1A-series Controller
being monitored is in RUN state before starting online program monitoring.
Starting Online Monitoring
Start online monitoring using either of the following methods:
1.
Select
Function
-
Monitoring
from the menu bar.
2.
Click the
Monitoring
Button on the toolbar.
During monitoring, the I/O tags or connections that are ON will be displayed in
a darker green color.
User-defined function block contents can be monitored.
Use the following procedure to start online monitoring.
Summary of Contents for DeviceNet Safety
