149
Setting the Operating Mode and Confirming the Cycle Time
Section 5-6
5-6
Setting the Operating Mode and Confirming the Cycle
Time
Click the
Mode/Cycle Time
Tab to display the NE1A-series Controller operat-
ing mode settings and the cycle time.
5-6-1
Setting the NE1A-series Controller Operating Mode
Automatic Execution Mode
Set the NE1A-series Controller automatic execution mode only after the sys-
tem has been configured (i.e., after downloading device parameters).
IMPORTANT
Even when Automatic Execution Mode is selected and the configuration has
been locked, the next startup will not be performed in RUN Mode if the power
is turned OFF in IDLE Mode. Turn OFF the power in RUN Mode to use auto-
matic execution.
Setting DeviceNet Communications
Disabling DeviceNet communications (Standalone Mode) shortens the NE1A-
series Controller cycle time. If you disable DeviceNet communications, you
will no longer be able to use any of the DeviceNet communications functions.
Automatic
Execution Mode
Description
Normal Mode
The Controller starts in IDLE Mode after the power supply is turned
ON.
To change to RUN Mode, the operating mode must be changed from
the Network Configurator.
Use this mode until device parameters have been verified.
Automatic Execution
Mode
If this mode is selected and the following conditions exist, the Con-
troller will start in RUN Mode after the power supply is turned ON:
• The configuration has been locked.
• The operating mode before the power was turned OFF was RUN
Mode.
Summary of Contents for DeviceNet Safety
