327
Appendix A
A-5-3
Setting TCP/IP Over a Network
Tools - TCP/IP Setting
Use the following procedure to set TCP/IP for an EtherNet/IP network.
1.
In the EtherNet/IP network, have only the target device and the Network Configurator operating. For the de-
fault IP address for a device that is to be used, refer to the operation manual for that device.
2.
Connect the Network Configurator online.
3.
Select
Tools - TCP/IP Setting
. The following window will be displayed.
4.
Specify the present IP address for the target device in the Set IP Address field.
5.
Make the required settings and then click the
Set to the Device
Button.
6.
With NE1A-series Controllers that support EtherNet/IP, the data that has been set will become valid when
the power is turned ON again.
Summary of Contents for DeviceNet Safety
