Omron CP1L - 12-2007, Operation Manual

Page: 358 / 673

325
Interrupt Functions
Section 6-1
Note The input interrupt (counter mode) function is one of the input interrupt func-
tions and executes an interrupt based on the pulse count. If the input pulse
frequency is too high, interrupts will occur too frequently and prevent normal
cyclic task processing. In this case, cycle time too long errors may occur or
the pulse input may not be read.
The maximum total frequency of the counter-mode interrupt inputs is 5 kHz.
Even in this case, the high frequencies may adversely affect other devices’
operation or the system load, so check the system’s operation thoroughly
before using the counters at high frequencies.
PLC Setup
The procedures for using the CX-Programmer to set the PLC Setup are the
same as the procedures for input interrupts (direct mode). Refer to
6-1-2 Input
Interrupts (Direct Mode) for details.
Writing the Ladder
Program
MSKS(690) Settings The MSKS(690) instruction must be executed in order to use input interrupts.
The settings made with MSKS(690) are enabled with just one execution, so in
general execute MSKS(690) in just one cycle using an up-differentiated condi-
tion.
MSKS(690) has the following two functions and three of the instructions are
used in combination. If up-differentiated input pulses are being used, the first
MSKS(690) instruction can be omitted since the input is set for up-differentia-
tion by default.
↓
Set the PLC Setup.
• Use the CX-Programmer to select the inter-
rupt inputs in the PLC Setup.
↓
Set the counter SVs.
• Set the interrupt counter SVs in the corre-
sponding AR Area words.
↓
Write the ladder program.
• Write the programs for the corresponding
interrupt task numbers.
• Use MSKS(690) to specify up-differentiation
or down-differentiation.
• Use MSKS(690) to enable input interrupts (in
counter mode).
MSKS(690)
N
S
MSKS(690)
N
S
Execution condition
2. Enables or disables the input interrupt.
1. Specifies up-differentiated or
down-differentiated inputs.