Mitsubishi Heavy Industries SRRM40HENG-L, Handbook, Page: 883 / 1106

FDC-HKX
881
Bolt positions for floor mounting hardware
Floor mounting hardware
Accessory
10 x 30 elongated hole
Use M8
As viewed from floor side.
Back
Front
806(1091)
(b) Bolt positions
1) Bolt positions for metal settings used for floor fixation.
•
Metal fitting used for floor fixation (accessories).
unit : mm
2) Bolt positions for wall fixation
Note (1) Value in ( ) indicates 71 type.
c) Level the unit using the level adjusting screw. Installation will be complrted after attaching side and front panel.
d) Exceute fixation following the directions described below.
(c) Installation of unit
1) Floor standing installation
a) Position of mounting bracket fixing bolts
Drill holes by referring to figures below.
Note (1) Be sure to use a bolt of the length for wall mouning.
b) The methed of drilling the wall is as follows.
●
When fixed on the floor
●
When fixed on the wall
When fixed on the wall
30 mm
Wall
Hole for piping
& wiring on floor
When fixed on the floor
2 places
4 places
Hole for piping &
wiring on wall
Bolt for wall mounting
Wall
Indoor
Outdoor
Sleeve
Ø70~86 mm
Sealing plate
Wall
Sleeve
Frame side panel
Mounting platc
(Accessory)
Tighten the bolt for floor
fixation using a flat washer
and double nut.
Tighten the bolt for wall
fixation using a flat washer
and double nut.
1150(1435)
112 786 (1071)
220
250
470
179
Elongated hole for
wall mounting
4 - 12 24
Use M10
Screw for adjusting
levelness.
unit : mm