Mitsubishi Heavy Industries SRRM40HENG-L, Handbook, Page: 153 / 1106

SCM-HG (4 room)
151
5) Connecting the drain pipes
a) Insert the drain hose as far as possible through the lower section of the side of the unit, and secure it with clamps.
b) The drain pipes should be set in a downward slope (over 1/100), and it should not have any bumps or traps along its
route.
c) The indoor drain pipes must be insulated.
6) Securing the wireless receiver
Note (1) Conduct the installation correctly, and ensure
that the water is draining correctly. It may lead
to water leaks.
a) With a (–) screwdriver, secure the installation frame to the grooves on either sides of the wireless receiver.
b) Refer to the installation Instructions for each separately sold part, regarding the installing location of the wireless
receiver.
4.5.2 Installation of remote controller
(1) Mounting method of battery (2) Fixing to pillar or wall
Uncover the remote control switch, and mount the batter-
ies (UM-4
×
2 pieces) in the body regularly.
(Fit the poles with the indication marks,
,
&
.
without
fail)
(a) Conventionally, operate the remote control switch by
holding in your hand.
(b) In the case of stationary operation service as by mount-
ing on the holder for the remote control switch, make
sure that the locating place is satisfactory for access
service before installing it.
(c) Avoid installing it on a clay wall etc.
Tapping screw
Drain hose
Bumps
Traps
Opposite
Clamp
Wireless receiver
Installation frame
Flat head
machine screw
Cover
Battery
Holder (remote control switch)
Adjust the installation to vertical attitude.
Avoid projecting the screw head.
Wood screw
ø3.5
×
16