
1046
FDC-HKXR
20.5.1 Installation of indoor unit
This is same as multi KX series. Refer to page 841~881.
20.5.2 Installation of the remote controller (Optional parts)
This is same as multi KX series. Refer to page 882.
20.5.3 Installation of outdoor unit
(1)
Selection of installation location
(a)
A palce where air will not be stagnant.
(b)
A place where the exhaust air will not be shorteyeled.
(c)
A place with enough space for air flow around the unit.
(d)
A place where the unit will not be affected by other heat sources.
(when there are multiple units installed or when units have another heat source)
(e)
A void installing the unit in places that are subject to sea air, sulfureous gas of the type found in hot springs, or any other
corrosive or flammable gas.
(f)
A place where smooth drainage of rain water and water formed by defrosting is acceptable.
(g)
In heating operation,
snow deposit on the heat-exchanger of outdoor unit must be prevented for keeping the normal
performance capacity.
•
Snow-hood no outdoor unit as in drawing, will reduce the frequency of defrost operation.
When installing the snow hood, take care so that the air outlet of the snow hood will not face directly into the most
windy direction.
•
Design the base higher than possible snow deposit.
(h)
A place where air outlet port is not exposed to strong wind.
(2)
Installation space
A place with enough space for air inlet, air outlet and service space.
(a)
Independent installation
Note (1) The unit can be installed bringing the right side close to the obstacle. In that case, provide a space over 500
mm to the left side.
1)
When there are obstacles on the sides and at the rear side of the unit
Dimension
Unit: mm
Installation
example
Distance
L
1
L
2
L
3
L
4
I
open
0
200
500
II
open
500
200
0
III
500
500
200
500
Summary of Contents for SRRM40HENG-L
