ETC Element Classic, User Manual

Page: 570 / 687

556 Ion Classic User Manual
Note:
sACN can be output on both ports. All other output protocols can only be
output on a single NIC.
sACN
This sets the control priority and the starting address for sACN data from your console. The
valid range for this setting is 1 (lowest) to 200 (highest). This is the reverse of EDMX.
Eos allows you to use any sACN universes from 1-63,999.The address range equals 1 to
32,767,488, which is 63,999 times 512.
Eos supports both the draft and ratified versions of sACN. The ratified version is output by
default unless this is changed.
Net2-EDMX
This sets the control priority for EDMX data from this console. The valid range for this setting is
20 (lowest) to 1 (highest). This is the reverse of sACN.
AVAB UDP
This sets the subnet for AVAB UDP data from this console. The priority levels range from 0-
200. The default is 0, which is no priority level. 1 is the lowest priority level and 200 is the
highest. When set to no priority level (0), the data will merge according to HTP.
A backup console will receive its AVAB UDP priority level from the primary. The backup will
then output at one priority higher than the primary, unless the primary was set to the highest
priority of 200.
Art-Net
This sets the subnet for Art-Net data from this console. The valid Art-Net Start range for this
setting is 0-255.
Broadcast Type
•
Directed Broadcast - Broadcast packets are directed to a subnet based on the IP address
and subnet mask of the sender.
•
Limited Broadcast - The limited broadcast address is 255.255.255.255. It is limited
because routers will never forward datagrams with that destination address. This means
that datagrams with the limited broadcast address are confined to the particular
network segment on which they originate.