DETEWE OpenCom 130, User Manual

Page: 36 / 204

Installation Available Ports
34
3.8 Available Ports
The OpenCom 100 has the following ports (see also Positions of the Ports starting
on page 37):
3.8.1 OpenCom 130
The listed interfaces and ports are located on the basic module of the
OpenCom 130. Further interfaces and ports can be added by installing the
expansion set and additional interface cards (see
Installing an Expansion Set
starting on page 26 and Installing Interface Cards starting on page 29).
■
One S
0
port to connect to an external S
0
bus (usually the NTBA), designed as an
RJ45 jack (S
0
1)
■
One switchable S
0
port (S
0
2), which can be connected as either an internal or
external S
0
bus. The internal connection is via a pressure terminal and the
external connection via an RJ45 jack.
■
Three U
pn
ports, designed as pressure terminals (U
pn
1 to U
pn
3)
■
Four analogue a/b ports, designed as pressure terminals (a/b1 to a/b4)
■
One slot to incorporate a doorstation equipment interface card. The following
ports can be used with such a card:
two actor ports for connection to a door opener and the intercom of door-
station equipment. These are designed as pressure terminals (actor1 to
activate a door opener and actor2 to activate doorstation equipment);
three sensor ports for connection to the bell keys of doorstation equipment,
designed as pressure terminals (sensor 1 to sensor 3)
■
One slot to incorporate a V.24 interface card. The following port can be used
with the V.24 add-on card:
one COM port to connect to a PC to configure and transmit connection data,
designed as an RJ45 jack
■
One port to the LAN (10BaseT), designed as an RJ45 jack