DETEWE OpenCom 130, User Manual

Page: 26 / 204

Installation Declarations of Conformity
24
Use a shielded Ethernet cable (STP cable, Shielded Twisted Pair cable) to connect
the OpenCom 100 to a Local Area Network (LAN).
Do not allow any fluid to penetrate the OpenCom 100, because this may cause
electric shocks or short circuits.
Do not install the OpenCom 100 during a storm. Do not connect or disconnect
lines during a storm.
The OpenCom 100 is designed for indoor use only. Lay the cables so that they
cannot be walked on or tripped over.
The connection of external devices to the sensor/actor should be performed by a
qualified electrician.
3.3 Declarations of Conformity
The OpenCom 130, OpenCom 131 and OpenCom 150 ITC systems conform to the
requirements set down in the EU directive 99/5/EC.
The Declaration of Conformity can be viewed at the DeTeWe Web site at
http://www.aastra-detewe.de.
3.4 Mounting Location
The ambient temperature for operating the OpenCom 100 must be b5
and +40°C. The power supply must be 230 V/50 Hz AC. A separate fuse for the
power supply is recommended.
To maintain the prescribed ambient temperature, mount the OpenCom 100 in a
well-ventilated location, away from direct sources of heat.
Do not position the OpenCom 100
■
in front of or above heat sources such as radiators,
■
in direct sunlight,
■
behind curtains,
■
in small, unventilated, damp rooms,