If torque and/or pinion-gear ring clearance is not within tolerance
values and the ring nuts have not been removed, mark the position
of the ring nuts (1) and remove the safety stops (2).
Adjusting clearance between pinion and gear ring.
To INCREASE: loosen the ring nut on gear ring side and tighten
the ring nut on non-gear ring side by the same measure.
To DECREASE: perform the same operations inversely.
To rotate ring nuts, use special wrench
T12.
Fit the stops (2) for the ring nuts (1). Engage stops in the slot next to
the holes provided for the check screws.
Coat screws (3) with Loctite 242 and tighten to a torque of 7±10
Nm.
Install negative brake cylinders and arms. For details, see
«CHECKING WEAR - REPLACING DISCS AND BRAKE SEALS».
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
92
ASSEMBLING AND INSTALLATION THE DIFFERENTIAL UNIT - ASSEMBLAGGIO ED INSTALLAZIONE GRUPPO DIFFERENZIALE -
DIFFERENTIALAGGREGAT ZUSAMMENBAUEN UND INSTALLIEREN - ASEMBLAJE Y INSTALACION GRUPO DIFERENCIAL -
ASSEMBLAGE ET INSTALLATION GROUPE DIFFERENTIEL
F1241933
1
2
3
F1241934
T12
T12
1
1
F1241935
1
2
3
F1241936