Loosen and remove check screws (9) from intermediate cover (10)
and apply a compressed air connection "
B
" to the lock's pressure
intake hole.
Thread: M14x1.5
Introduce low-pressure compressed air through connection "
B
"
and make sure that the lock control piston comes out at end of
stroke.
Remove safety studs, rotate cover (10) to an angle of about 45ë
and remove cover.
Tighten two safety studs "
A
" (M16) in the main body.
Loosen and pull out check screws (9) from intermediate cover (11)
on gear ring side.
Support the differential unit and disconnect intermediate cover (11)
from main body (3).
Pull out cover (11).
Remove the differential unit by using tool
T13
; position the unit on
a workbench.
Remove the snap ring (12) and locking cap (13).
NOTE.
Replace the cap at each disassembly.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
110
REMOVING AND DISASSEMBLING THE HYDRAULIC DIFFERENTIAL UNIT - RIMOZIONE E SMONTAGGIO DIFFERENZIALE A COMANDO
IDRAULICO - DIFFERENTIAL MIT HYDRAULISCHER STEUERUNG ABNEHMEN UND ABMONTIEREN - REMOCION Y DESMONTAJE
DIFERENCIAL A MANDO HIDRAULICO - RETRAIT ET DEMONTAGE DU DIFFERENTIEL A COMMANDE HYDRAULIQUE
F1241918
11
3
F1241917
9
11
F1241891
10
9
F1241890
10
F1241874
T13
F1241919
12
13