Fit the flange (14) in the gear ring (13) and lock into position with
snap ring (12).
NOTE.
Check that snap ring (12) is fully inserted in the slot of gear
ring (13).
Mount gears (10) onto the pins of the planetary cover (2).
To insert gears, use tool
T21
.
ATTENTION!
The radiused part of bearings' inner ring must face
the bottom of the pin.
Lock gears (10) into position by installing the snap rings (9).
Oil the seal ring and bushing; slip the steering case (3) onto the
twin U-joint, fit the pivot pins and connect the steering bar.
For details, see «ASSEMBLING THE COMPLETE STEERING
CASE» and «INSTALLING THE STEERING CYLINDER».
Only if studs have been removed.
Apply a coat of Loctite 270 to
the fast end of studs (19) and apply Tecnolube 101 to ground nut
end; tighten studs (19) as far as they will go.
Install the wheel hub (7) onto the steering case (3).
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
56
ASSEMBLING THE EPICYCLICAL REDUCTION GEAR - ASSEMBLAGGIO RIDUTTORE EPICICLOIDALE -
ZUSAMMENBAU DES PLANETENGETRIEBES - ASEMBLAJE REDUCTOR EPICICLOIDAL - ASSEMBLAGE DU REDUCTEUR EPICYCLOIDAL
F1241738
12
13
14
F1241739
T21
9
2
10
2
10
F1241817
9
10
F1241848
3
D1240268
Loctite 270
Tecnolube 101
19
F1241818
3
7