Fit seal (8) on the outside of the head (2).
ATTENTION!
1 - To ease installation, grease the outer surface of the piston
2 - Do not roll the seal (8).
Prepare piston (5) by fitting it with guide ring (9), magnetic ring (10),
O-ring (11) and seal (12).
ATTENTION!
1 - To ease installation, lubricate with grease
2 - If a centring sensor is not required, the magnetic ring (10) can be
replaced with an additional guide ring (9).
Apply tool
T11
to the piston rod on non head side (2) and centre rod
into cylinder (3) so as to fit it into piston (5).
NOTE.
Lightly grease seals and cylinder.
Introduce the piston (5) into the cylinder by about 150 mm using a
plastic hammer.
Remove tool
T11
and apply it to the opposite side of the piston (5).
Grease the seals of the head (2), slip the head onto the piston and,
using a plastic hammer, introduce head into cylinder (3).
NOTE.
Introduce the head so it is flush with the cylinder.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
74
ASSEMBLING THE STEERING CYLINDER - MONTAGGIO CILINDRO DI STERZATURA - LENKZYLINDER MONTIEREN -
MONTAJE CILINDRO DE DESVIO - MONTAGE CYLINDRE DE DIRECTION
D1240235
8
2
D1240236
5
9
10
11
12
F1241754
T11
3
5
F1241755
5
F1241756
T11
5
F1241757
2
3