Apply Loctite to the threaded portion of the steering bars and
connect the bars by tightening the ends in the piston rod.
Tightening torque: 430±470 Nm.
ATTENTION!
Accurately remove grease from the threads using an
activator before applying the thread locking compound.
Introduce the pins (3) in the steering cases (5) and lock into position
with nuts (2) tightened to a torque of 350±390 Nm.
If required, install the proximity sensor (1) for checking piston
centring and tighten screws (13).
Tightening torque: 5±6 Nm
ATTENTION!
If required, eliminate the action of the negative
brake.
Apply tools
T10
onto the wheel hubs and lock tools.
Check that tools are perfectly flat and parallel to each other using a
level "
B
".
Connect the sensor (1) to the control device according to either of
the following diagrams.
Sensor wiring diagram for STANDARD version.
GB
GB
GB
GB
GB
GB
a
b
c
d
f
e
64
INSTALLING THE STEERING CYLINDER - INSTALLAZIONE CILINDRO DI STERZATURA - LENKZYLINDER INSTALLIEREN -
INSTALACION CILINDRO DE DESVIO - INSTALLATION CYLINDRE DE DIRECTION
F1241821
F1241822
2
3
5
F1241856
1
13
F1241857
T10
B
F1241858
1
D1240029
1
2
3
4
--
+
I max=0,80 A
NERO
BLACK
BLU
BLUE
MARRONE
BROWN
2 A
CONNETTORE
CONNECTOR
BATTERIA
BATTERY