Atlas Copco PowerMACS 4000, User Manual

Page: 658 / 668

Appendix
658 9836 3521 01

5262, TC 1, Error reading reference from spindle. Ref 3, Status 50

5262, TC 1, Error reading reference from spindle. Ref 4, Status 50

5262, TC 1, Error reading reference from spindle. Ref 11, Status 50

5262, TC 1, Error reading reference from spindle. Ref 32, Status 50

5262, TC 1, Error reading reference from spindle. Ref 60, Status 50

5262, TC 1, Error reading reference from spindle. Ref 61, Status 50

5262, TC 1, Error reading reference from spindle. Ref 62, Status 50

5262, TC 1, Error reading reference from spindle. Ref 63, Status 50

5262, TC 1, Error reading reference from spindle. Ref 64, Status 50

5262, TC 1, Error reading reference from spindle. Ref 65, Status 50

5262, TC 1, Error reading reference from spindle. Ref 89, Status 50

5262, TC 1, Error reading reference from spindle. Ref 90, Status 50

5262, TC 1, Error reading reference from spindle. Ref 100, Status 50

5262, TC 1, Error reading reference from spindle. Ref 109, Status 50

5262, TC 1, Error reading reference from spindle. Ref 170, Status 50

5262, TC 1, Error writing reference to spindle. Ref 62, Status 21
after which the Box is programmed with default values.
When the Box is programmed all parameters that are important for controlling the spindle, including the
calibration parameters, are set. However, the following parameters are left unchanged:

The serial number of the spindle

The total number of cycles run

The total number of cycles run at last service

The date when the last service was made
The value of these parameters can be set, at any time, using the new "Service Data" page of the TTPM
Spindle Set Up form when on-line to a spindle of Conversion Box type.