Atlas Copco PowerMACS 4000, User Manual

Page: 474 / 668

Peripheral Devices
474 9836 3521 01
Field Bytes Value sent
Version 2
“
3
“
Character Code 20
“
ISO-8859-1
“
Sequence Number 4
Length of User Data 6
Byte Order 1 Always 0 = Intel byte order
Maintenance Sequence User Data
Field Bytes Value sent
Manufacturer
Identification
5
“
AC
“
Facility Type 2
1 if Facility type = “Fastening” and 4 if = “Adjustment,
for the moment always 1
Date 10 Cycle start time
Time 8 Cycle start time
Maintenance Sequence,
AFU-number
30 See description below.
Event Number 15 Empty
Maintenance Sequence
Text
50
“Bolt name” + “-“ + “Program name”
e.g. “
Bolt 01-Test run
”, “
Left bolt-Tighten left bolt
”
Tool-ID 10 Spindle serial number from the spindle setup, if it is specified.
Unit Carrier ID 10 Result variable Id res 2, only the 10 first characters are used.
Type 10 Result variable Id res 3, only the 10 first characters are used.
Identification 30
Result variable Id res 1 or Wp ID, depending on the selection in the
I-P.M. reporter, only the 30 first characters are used.
Additional ID 10 Result variable Id res 4, only the 10 first characters are used.
Curve 1
0 = without trace
1 = with trace
Status 2
0 = OK or OKR
1 = NOK, TERMNOK or NOKRM
This is always the bolt status; a bolt can be OK even if the station is
NOK.
Mode 1 Always 0 = automatic mode
Loosen 1
“ “ = not available.
Number of additional
information
2
Always “
0
“, no additional information is available
Number of Error Codes 2
Error Code (for every
error)
5 See table below for possible error codes