Atlas Copco PowerMACS 4000, User Manual

Page: 468 / 668

Peripheral Devices
468 9836 3521 01
8.11.4.9 TC Result Formats for PDT
The tightening results are reported to PLUS according to the specification.
Station data:
Field Implementation
QUALITÄTSAUSSAGE-ORTS-NR QO Station QO in the cycle data.
JOB-NR JN Mode number for the tightening.
GESAMT-Q-AUSSAGE GQ Station status of a tightening.
1 = OK is sent for status OK and OKR (OK after repair)
0 = NOK is sent for status NOK and TERMNOK (failed
during termination).
GESAMT-STATUS GS Always 0
SOLL-ANZAHL-EINZELERGEBNISSE SA Station SA in the cycle data.
EINZELERGEBNIS-TYP-KZ ET The value in Station ET.
Bolt data:
Field Implementation
EINZELERGEBNIS-NR EN Bolt number from ToolsTalk PowerMACS setup.
EINZELERGEBNIS-IDENT EI Bolt name from ToolsTalk PowerMACS setup. The bolt
number will be added at the end of the bolt name to reach 24
characters.
EINZELERGEBNIS-Q-AUSSAGE EQ Bolt status for this tightening
1 = OK is sent for status OK and OKR (OK after repair)
0 = NOK is sent for status NOK, TERMNOK (failed during
termination) and NOKRM (not successful due to reject
management)
EINZELERGEBNIS-STATUS ES Always 0
EINZELERGEBNIS-QA-DETAIL ED Customer Error Code in the cycle data.
ANLAGEN-ORTS-NR AO Will always be the same as QO for all bolts.
ANLAGEN-BETREIBER AB Station AB in the cycle data, always the same for all bolts.
USER-ID US Id Res 4 in the cycle data, always the same for all bolts.