Atlas Copco PowerMACS 4000, User Manual

Page: 600 / 668

Peripheral Devices
600 9836 3521 01
8.15.2 Interface definition output
Two output maps are defined in the PowerMACS, one for systems with up to five (5) spindles and one for
systems with up to sixteen (16) spindles. Only one of the maps can be enabled at a given time. The maps
are enabled/disabled manually by changing the
PLC bytes Out parameter. All outputs are stable for at
least 500 ms. The output map definition for signals from PowerMACS is according to the following table:
Word Byte Bit Name in DeviceNet map Name of I/O signal
0
0
0 Spare
1 Spare
2-3 Spare
4-6 Spindle
– Mode Set Code (0-7)
DO_GM_ParSet1 - 4
7 Global Accept DO_GM_GlobalAccept
1
0 Spindle
– In Cycle
DO_GM_InCycle
1 Spare
2 Fault Relay DO_GM_FaultRelay
3 Spindle
– Cycle Complete
DO_GM_CycleComp
4 Spindle
– Error Proofing Ready (EPR)
DO_GM_EprOut
5-7 Spare
1
0
0 Spindle
– 1 Good Rundown (Green Light)
DO_GM_Green_Sp1
1 Spindle
– 1 Remove (Red Light)
DO_GM_Red_Sp1
2 Spindle
– 1 Low Torque (Yellow Light)
DO_GM_Yellow_Sp1
3 Spindle
– 2 Good Rundown (Green Light)
DO_GM_Green_Sp2
4 Spindle
– 2 Remove (Red Light)
DO_GM_Red_Sp2
5 Spindle
– 2 Low Torque (Yellow Light)
DO_GM_Yellow_Sp2
6 Spindle
– 3 Good Rundown (Green Light)
DO_GM_Green_Sp3
7 Spindle
– 3 Remove (Red Light)
DO_GM_Red_Sp3
1
0 Spindle
– 3 Low Torque (Yellow Light)
DO_GM_Yellow_Sp3
1 Spindle
– 4 Good Rundown (Green Light)
DO_GM_Green_Sp4
2 Spindle
– 4 Remove (Red Light)
DO_GM_Red_Sp4
3 Spindle
– 4 Low Torque (Yellow Light)
DO_GM_Yellow_Sp4
4 Spindle
– 5 Good Rundown (Green Light)
DO_GM_Green_Sp5
5 Spindle
– 5 Remove (Red Light)
DO_GM_Red_Sp5
6 Spindle
– 5 Low Torque (Yellow Light)
DO_GM_Yellow_Sp5
7 Spare
Note! The above shows the output for a system with up to 5 spindles. For a system with up to 16
spindles just continue the table with spindle 6, and so on.