Omron CJ1W-MA - REV 10-2008, Руководство по эксплуатации

Страница: 61 / 644

34
Nomenclature and Functions Section 3-1
For details, refer to the JUSP-NS115 MECHATROLINK-II Application Module
User’s Manual .
Note Refer to the user’s manual for the Servo Drive for the nomenclature and func-
tions of Servo Drives with Built-in MECHATROLINK-II Communications.
• G-series Servo Drives with Built-in MECHATROLINK-II Communications
(R88D-GN @ -ML2)
• W-series Servo Drives with Built-in MECHATROLINK-II Communications
(R88D-WN
@
-ML2)
• SMARTSTEP Junior Servo Drives with Built-in MECHATROLINK-II Com-
munications (R7D-ZN @ -ML2)
LED Indicators The LED Indicators show the operating status of the JUSP-NS115.
Note The Alarm Status LED will also be lit when MECHATROLINK communications
are not established with the PCU.
Station Address Setting
Switch (SW1) Set the Servo Drive's station address in conjunction with the MECHA-
TROLINK-II communications setting on pin 3 of the Communications Setting
DIP Switch (SW2).
Setting Range: 0 to F (See the following table.)
Note The factory default setting is 1.
Communications Setting
DIP Switch (SW2) Sets the MECHATROLINK-II communications settings.
A
R
LED Name Color Status Details
A Alarm Status Red Lit An alarm occurred in the Servo
Drive. (See note.)
Not lit Other condition
R MECHA-
TROLINK-II
Communica-
tions Status Green Lit MECHATROLINK communica-
tions in progress
Not lit MECHATROLINK communica-
tions stopped
0
8
C 4
3
2
1 F
E
D
5
6
7 9
A
B
Pin 3 of
SW2
SW1 Station
address
Note
OFF 0 --- Cannot be used. Do not set.
1 to F 1 to 15 ---
ON 0 16 ---
1 to F --- Cannot be used when connecting to the
PCU. Do not set.
1 2 3 4
O
N