Omron CJ1W-MA - REV 10-2008, Руководство по эксплуатации

Страница: 308 / 644

281
Origin Search Operation Section 8-2
When using an absolute encoder, make sure that the settings for the encoder
type in the Axis Parameters and
Operation Switch when Using Absolute
Encoder (Pn00B for G Series and Pn002.2 for W Series) in the Servo Param-
eters match.
A motor with an absolute encoder cannot be used with a SMARTSTEP Junior
Servo Drive. When using a SMARTSTEP Junior Servo Drive, Pn002.2 is not
supported. Use the Servo Drive as for an incremental encoder.
If the settings do not agree, origin searches may not be possible and other
malfunctions may occur.
Command Unit Parameters
The command unit default setting is pulses.
G-series Acceleration/Deceleration Constants
Model Parameter
No.
Parameter name Unit Setting
range
Parameter
size
Default
setting
R88D-GN @ -
ML2
Pn205 Electronic gear ratio 1 (numerator) --- 1 to
1073741824 4 1
Pn206 Electronic gear ratio 2 (denominator) --- 1 to
1073741824 4 1
R88D-WT @ Pn202 Electronic gear ratio G1 (numerator) --- 1 to 65535 2 4
Pn203 Electronic gear ratio G2 (denominator) --- 1 to 65535 2 1
R88D-WN @ -
ML2
Pn20E Electronic gear ratio G1 (numerator) --- 1 to
1073741824 4 4
Pn210 Electronic gear ratio G2 (denominator) --- 1 to
1073741824 4 1
SMART-
STEP Junior Pn20E Electronic gear ratio G1 (numerator) --- 1 to
1073741824 4 1
Pn210 Electronic gear ratio G2 (denominator) --- 1 to
1073741824 4 1
Type Parame-
ter No.
Parameter name Unit Setting
range
Parame-
ter size
Default
setting
Accelera-
tion/
decelera-
tion con-
stants Pn107 Linear acceleration con-
stant 10,000
command
units/s
2
−
32768
to 32767
2 100
Pn10A Linear deceleration con-
stant 10,000
command
units/s
2
−
32768
to 32767
2 100
Accelera-
tion/
decelera-
tion filters Pn10E Moving average time 0.1 ms 0 to 5100 2 0