Omron CJ1W-MA - REV 10-2008, Руководство по эксплуатации

Страница: 382 / 644

355
Override Section 10-3
The direction designation setting when the jogging operation starts (Jog Bit
turns ON) is enabled. Even if the designation is changed during jogging, the
direction will not change. Jogging decelerates to a stop when the Jog Bit turns
OFF.
The Busy Flag remains ON during the jogging operation. The PCU Position-
ing Completed Flag does not turn ON when jogging stops.
Timing Chart
The following timing chart is for when JOG is executed in the forward rotation
direction.
10-3 Override
10-3-1 Overview
The override operation is used to change the speed of an active axis. While
the Override Enable Bit is ON, the target speed is changed by applying the
override value that is set in the Axis Operating Output Memory Area.
The override can be set from 0.01% to 327.67% in units of 0.01%. The speed
command values (Speed command value for speed control in speed control
mode) set for direct operation, origin return, jogging, and speed control opera-
tions are taken to be 100%.
The override function is disabled during origin search or torque control.
The target speed when override is enabled is as follows:
3E8 hex (1000)
1000
5DC hex (1500)
1500
Speed command value
(words a+4, a+5)
JOG (word a, bit 09)
Direction designation
(word a, bit 10)
Speed
Receiving Command
Flag (word b, bit 00)
PCU Positioning Completed
Flag (word b, bit 05)
Busy Flag (word b, bit 13)
Direction designation
changed Target speed
changed Jogging stopped
(JOG Bit OFF)
a = Beginning word of Axis Operating Output Areas specified in Common Para (Axis No.
−
1)
×
25
b = Beginning word of Axis Operating Input Areas specified in Common Para (Axis No.
−
1)
×
25
The target speed can be changed at any
time by overwriting the speed command
value.
The direction designation setting at the start
of the jogging operation is enabled. Even if
the designation is changed during jogging,
the direction of operation will not change.
Solid line: Command speed
Broken line: Feedback speed
Time
The Receiving Command Flag turns ON
for at least one cycle time when the
command to start jogging is received.
The PCU Positioning Completed Flag
turns OFF when jogging starts. The PCU
Positioning Completed Flag does not turn
ON when the jogging operation stops.
The Busy Flag remains ON during the
jogging operation.
When jogging stops, the Busy Flag turns
OFF when sending the command is
completed, regardless of the number of
pulses remaining in the Servo Drive.
Target speed = Speed command value
×
Override
10000