Field
Option
Description
Relative to
centreline
Slope signs defined relative to the centreline.
+
+
+
+
Road_054a
Relative
from cen-
treline
Slope signs defined relative from the centre-
line.
+
+
+
Road_054b
Extend
slopes
When using slopes generated by a design
package, the quality of the change from cut
to fill or where slopes start and end,
depends on the terrain model used for the
project. Occasionally, one of the lines defin-
ing the slope ends before intersecting with
the natural surface. A message appears ask-
ing to extend the slope, as soon as a meas-
urement is taken outside of the defined
design slope.
Yes (show
message)
The slope is expanded beyond and above or
below the hinge point. A warning is shown
as soon as leaving the defined slope.
Yes
The slope is expanded beyond and above or
below the hinge point. No warning is when
leaving the defined slope.
No
The slope is not expanded beyond and above
or below the hinge point.
Allow meas-
uring
beyond
design
Check box
Extend each line or curve at its beginning
and end with a tangent. The extension is
used for projecting a point to the line and for
intersecting the line.
Roads - General
633
Содержание Captivate
