Key
Description
OK
To measure the entered point and to access
Select Points -
Measure
.
Done
To finish selection of points and access
Measure sets of
angles
for further steps.
Fn
Settings
To configure the Sets of Angles app.
Fn
Get Pt
To select points from the design job.
Description of fields
Field
Option
Description
Use precise
target aim-
ing
Check box
Available for the 0.5" instruments of TS60.
When this box is checked, four ATRplus
measurements are performed and the mean
value out the measurements is considered
for the angle value.
Use ultra
fine aiming
Check box
Reduces the field of view of the ATRplus. The
setting is only applied for
Aim at target
:
Automatic
in
Measure & Target
.
Automati-
cally meas-
ure points
Check box
Available for instruments with automatic aim-
ing and
Aim at target:Automatic
. If
checked, search and measurements are done
to specified targets in sets.
Next step
IF
THEN
new or selected points are to
be measured
OK
to access
Select Points - Measure
.
existing points are to be
selected
Fn
Get Pt
to select a point from the design
job.
all desired points have been
selected and measured
Done
to return to the previous panel.
Define Points for Set
856
Sets of Angles - TS
Содержание Captivate
