Danfoss ED-DT318B, Инструкция по установке и эксплуатации

Страница: 136 / 186

Installation and Operation Guide
ED-DT318B
Drive Train Systems with Traction Control, Inverter/Controller, and Motor with 2 Speed Transmission
BC353060341319en-000101 Revision D © Danfoss | November 2020 | 135
Classified as Business
Figure 8.17: Logging Set Up Dialog Box
Table 8.7: Logging Set Up Components
Label Description
Directory:
Browse button Enter the directory where Log files should be written. Browse brings up a File
Open dialog box. Use it to point to the directory you want to use.
Include in Name Text that you want included into the log filename. It includes the date, this text,
and an incrementing number.
Log when stopped Normally logging only occurs when the motor is spinning. If you want data to be
logged at all times, then select this box.
Logging Rate Select the rate that you want data logged.
Lines Per File
Enter the number of rows you want in each logging file. The diagnostic software
will open a new file (incremented name) when this number of rows has been
stored into a logging file.
In general, Data Logging stores one snapshot of measurement data every second or at an integer multiple of
seconds. The fastest rate that data can be logged is four times a second. If you need faster data acquisition, then
you should use the data acquisition feature of the Danfoss Power Solutions Motor System (see
Section 8.5 ).
NOTICE
Logging at a four or two times per second rate will slow down the extraction of a data
acquisition file.
This data is stored in a spreadsheet file, with a snapshot of data measurements forming one row in the
spreadsheet. The file format used is the comma-separated values (CSV) format. You can control the size of these
files using the logging setup and the
Lines Per File
setting. By default, 25,000 rows of data are stored per file.
Once a file is full, it is closed, and the next incremented file name is opened.