Abbott CELL-DYN 3000, Руководство оператора

Страница: 223 / 542

5-94
CELL-DYN

3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
Using the Work List Without Bar Codes
When the Bar Code OFF option is selected, samples must be run in the
order in which the information has been entered in the Work List, since
the Work List is accessed sequentially as the samples are processed.
NOTE: Special “Q Labels” are available to identify QC
samples. QC samples should not be entered in the Work List.
The Q label identifies the sample as a QC sample and the results
are automatically transmitted to the appropriate file.
Sample identification is made from the information entered in the
<SPECIMEN ID> field on the Work List. If no entries are made in the
<SPECIMEN ID> field, the Sample Loader identifies the sample by the
rack and tube number (position of the tube in the rack). The identification
is displayed as RnTn.
CAUTION: If a Sample Loader fault occurs that necessitates
initialization of the Sample Loader, remove all samples that have
been processed before restarting the Sample Loader. If these
samples are not removed, misidentification of the remaining
samples will occur.
Sample Analysis Procedure
1. Follow the instructions in the Work List Set Up Procedure to
configure the Work List.
2. If necessary, from the main WORK LIST Screen , press [WORK
LIST ON] to enable the Work List.
3. If necessary, press [BAR CODE OFF] to disable the bar code
function.
4. Type the appropriate sample identification information in the
<SPECIMEN ID> and <SPECIMEN NAME> (if selected) entry
fields on the Work List. Press the Enter key on the keyboard to save
the entry in each field and advance the cursor.
5. If selected, type the appropriate information in the <LIMIT> and
<PARAM> entry fields. Press the Enter key on the keyboard to
save the entry in each field and advance the cursor.
NOTE: If no entries are made in these fields, the default
selections are used.
Search Go Back Book TOC