Sony GY-2120WD, Maintenance Manual

Page: 404 / 484

6-180
GY-2120WD/WS
n
The screen display when commands in which the output result differs from the ordinary result are execut-
ed is shown below. When these commands are executed, press the RECOVER hole and display the
DIAG normal termination screen to select the command below after the contents of the display are
confirmed.
Command <LCD Display>
006 Serial No. display Serial #xxxxx
061 Hours meter display : Operation hours Oper:xxxxxxH
062 Hours meter display : Drum hours (for replacement) Drum1:xxxxxxH
063 Hours meter display : Drum hours (for cleaning) Drum2:xxxxxxH
065 Hours meter display : Tape run hours Tape:xxxxxxH
066 Threading count display Thrd:xxxxxx
071 SCSI ID display SCSI ID[5]
072 DIP SW display : Rear Panel DIP SW RP DIP:xxxxxxxx (1=ON,0=OFF)
073 DIP SW display : IF board DIP SW S201 IF S201:xxxx
074 DIP SW display : IF board DIP SW S202 IF S202:xxxxxxxx
075 SERV set valne display MSW1:4100000 *
Not in use
COMP SW mode (0:OFF/1:ON)
A-A mode (0:OFF/1:ON)
PetaServe mode (0:OFF/1:ON)
REW bit mode (0:OFF/1:ON)
BT bit ignore mode (0:OFF/1:ON)
Ignore Wide Residue mode (0:OFF/1:ON)
RS-232C baud Rate
(0:2400bps/1:4800bps/2:9600bps/
3:19200bps/4:38400bps)
091 ROM version display : SCSI CPU SCSI ROM Vx.xx
092 ROM version display : SYS CPU SYS ROM Vx.xx
093 ROM version display : IF CPU IF ROM Vx.xx
094 ROM version display : SV CPU SV ROM Vx.xx
095 ROM version display : EQ CPU EQ ROM Vx.xx
096 ROM version display : DR CPU DR ROM Vx.xx
097 Firmware revision display Rev. GYx.xx
Indicates switches as
1, 2, 3...etc. in the direction
from left to right.
6-3. Error Processing