Siemens 6RA7013-6DV62, Operating Instructions Manual

Page: 163 / 734

05.05 Start-Up
SIEMENS AG 6RX1700-0AD76
7-5
SIMOREG DC Master Operating Instructions
Control bits from OP1S operator panel:
(see also function diagram "OP1S operational display" (Section 8, Sheet Z123) and the OP1S
operating instructions)
Data are exchanged between the OP1S and SIMOREG 6RA70 converter via the G-SST1 interface
(RS485) and USS protocol.
The OP1S operator panel transfers the following control bits in process data word 1 in the USS
message:
Key on OP1S Function *)
Bit in PZD word1
(connector K2001)
Binector
ON key / OFF key (I / 0) ON / OFF1 Bit 0 B2100
Reset Acknowledge Bit 7 B2107
Jog Jog (inch) Bit 8 B2108
Reverse Enable positive direction of rotation Bit 11 B2111
Enable negative direction of rotation Bit 12 B2112
UP key Increase motorized potentiometer Bit 13 B2113
DOWN key Decrease motorized potentiometer Bit 14 B2114
*) Suggested functions. Since binectors can be freely wired up to any selector switch, the control signals from the OP1S
can be used for any type of control task in the SIMOREG 6RA70.
Connection of control signals from the OP1S for the suggested functions:
Functions can be implemented via the OP1S only if the following conditions are fulfilled:
1) Bit-by-bit input of control bits in control word 1 (P648 = 9), see also Section 8, Function
Diagrams, Sheet G180
2) OP1S in "Operational display" status
ON / OFF1:
Parameterization of switch-on/shutdown via OP1S by setting
P654 = 2100
Please also note AND operation with "Switch-on/Shutdown" from terminal 37 (see also Function
Diagrams, Sheet G130 in Section 8 and Section "Switch-on/Shutdown (ON / OFF) terminal 37" in
Section 9)
Acknowledge:
Parameterization of fault message acknowledgements via OP1S by setting
P665, P666 or P667 = 2107
Faults can always be acknowledged by pressing the <P> key on the PMU.
Inching:
Parameterization of inching via OP1S by setting
P668 or P669 = 2108
Selection of source of inching setpoint via the corresponding index of P436 (see "Inching setpoint"
function diagram)
Direction of rotation enable:
Parameterization of direction of rotation enabling via OP1S by setting
P671 = 2111 (positive direction of rotation)
P672 = 2112 (negative direction of rotation)
Motorized potentiometer:
Parameterization of motorized potentiometer via OP1S by setting
P673 = 2113 (higher)
P674 = 2114 (lower)
P644 = 240 (main setpoint from motorized potentiometer)