Siemens 6RA7013-6DV62, Operating Instructions Manual

Page: 607 / 734

05.05 Parameter list
SIEMENS AG 6RX1700-0AD76
11-143
SIMOREG DC Master Operating Instructions
PNU
Description Value range
[Unit]
Steps No. indices
Factory
setting
Type See
Change
(Access /
Status)
Technology controller: Control bits
U500
(2500)
*
S00
(B170)
Source for technology controller enabling command FB 114
0 = binector B0000
1 = binector B0001
etc.
All binector numbers
1 Ind: None
FS=0
Type: L2 P052 = 3
P051 = 40
Offline
U502
(2502)
*
S00
FDS
(B170)
PI/PID controller switchover FB 114
0 PI controller (D component is applied only in actual-value
channel)
1 PID controller (D component is applied for control deviation)
0 to 1
1 Ind: 4
FS=0
Type: O2 P052 = 3
P051 = 40
Offline
U503
(2503)
*
S00
FDS
(B170)
Set P component to zero FB 114
0 Set controller P component to zero (i.e. to obtain pure I
controller)
1 Controller P component is active
0 to 1
1 Ind: 4
FS=1
Type: O2 P052 = 3
P051 = 40
Offline
U504
(2504)
*
S00
FDS
(B170)
Set I component to zero FB 114
0 Set controller I component to zero (i.e. to obtain pure P
controller)
1 Controller I component is active
0 to 1
1 Ind: 4
FS=1
Type: O2 P052 = 3
P051 = 40
Offline
Technology controller: Set I component
When the state of the binector selected in U506 switches from log. "0" to "1", the I component of the technology controller is set to the
value parameterized in U505.
With this function it is possible, for example, to use the same signal (binector) to control controller enabling commands and setting of the I
component.
U505
(2505)
*
S00
(B170)
Source for setting value for I component FB 114
0 = connector K0000
1 = connector K0001
etc.
All connector
numbers
1 Ind: None
FS=0
Type: L2 P052 = 3
P051 = 40
Offline
U506
(2506)
*
S00
(B170)
Source for control bit "Set I component" FB 114
0 = binector B0000
1 = binector B0001
etc.
All binector numbers
1 Ind: None
FS=0
Type: L2 P052 = 3
P051 = 40
Offline
Technology controller: Output, limitation
U507
(2507)
*
S00
(B170)
Source for variable positive limit FB 114
After multiplication with U508, the contents of the selected connector act as
a positive limit for the technology controller output.
0 = connector K0000
1 = connector K0001
etc.
Note:
If the selected connector contains a negative value, a negative maximum
value is applied to the output of this limiter stage.
All connector
numbers
1 Ind: None
FS=1
Type: L2 P052 = 3
P051 = 40
Offline
U508
(2508)
S00
FDS
(B170)
Positive limit for output of technology controller FB 114
See also U507
0.0 to 199.9
[%]
0.1 Ind: 4
FS=100.0
Type: O2 P052 = 3
P051 = 40
Online