Omron SYSDRIVE 3G3MV-A2001, User Manual

Page: 98 / 344

4-6
3 Initializing Parameters
•
Initialize the parameters using the following procedure.
•
To initialize the parameters, set n01 to 8.
Key sequence Indicator Display
example
Explanation
Power On
Press the Mode Key repeatedly until the PRGM indicator
is lit.
Press the Enter Key. The data of n001 will be displayed.
Use the Increment or Decrement Key to set n01 to 8.
The display will flash.
Press the Enter Key so that the set value will be entered
and the data display will be lit.
--- Parameter n001 will be initialized and reset to 1 from 8.
In approximately
1 s. The parameter number will be displayed.
4 Setting the Motor Current Parameter
•
Run the Inverter in V/f control mode for trial operation. The control mode is not initialized. Therefore,
set n002 to 0 for V/f control. Set the motor current parameter in n036 in order to prevent the motor from
burning due to overloading.
H
Control Mode Setting
Parame-
ter
Register Name Description Setting
range
Unit of
setting
Default
setting
Chan-
ges dur-
ing
opera-
tion
n002 0102 Control
mode
selection Sets the control mode for the
Inverter.
0: V/f control mode
1: Vector control mode
Note 1. The control mode
is not initialized
with n001 set-
tings.
Note 2. There are param-
eters that are
changed accord-
ing to the set
value in n002. For
details, refer to
5-1-2 Setting the
Control Mode
(n002)
.
0, 1 1 0 No
Test Run
Chapter 4