Omron CRT1 - 10-2009, Operation Manual

Page: 95 / 675

71
Preparing Flat Connectors
Section 3-3
■
Cutting the Cable
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
■
Attaching the Cable
1,2,3... 1. As shown in the diagram below, place the cable so that the white line is in
the direction of the side with the open cover, with the white line on the cable
facing upward.
2. Hold the cable so that it does not move and close the cover.
■
Pressure-welding the Connector
Use the DWT-A02 Pliers to pressure-weld the connector.
1,2,3... 1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
White line
(Side with cover open)
From the left: red, white, blue, and black
Connector position reference surfaces