Omron CRT1 - 10-2009, Operation Manual

Page: 342 / 675

318
Summary of the Analog Input Slave Units
Section 6-2
Hold Flags (Output) Hold Flags are used with the peak/bottom hold and top/valley hold functions.
The Hold Flags are used to control the hold execution timing from the Master
Unit and are allocated in the Master Unit using the following data format (1
word (2 bytes)).
The meaning for each bit is as described below.
Note After a Hold Flag is turned ON at the Master Unit, there is a transmission time
delay for notification of this to the unit.
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
+0 Analog Data 1 for Input CH0 Lower byte
+1 Upper byte
+2 Analog Data 1 for Input CH1 Lower byte
+3 Upper byte
+4 Analog Data 1 for Input CH2 Lower byte
+5 Upper byte
+6 Analog Data 1 for Input CH3 Lower byte
+7 Upper byte
+8 0 0 0 0 V_ST3 V_ST2 V_ST1 V_ST0 Lower byte
+9 0 0 0 0 T_ST3 T_ST2 T_ST1 T_ST0 Upper byte
15 8 7 0
+1 +0
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
+0 0 0 0 0 HD3 HD2 HD1 HD0 Lower
byte
+1 0 0 0 0 0 0 0 0 Upper
byte
Bit Abbreviation Name Details
0 HD0 Hold Flag for
Input CH0 The hold function is performed for Analog
Input CH0 while this flag is ON. The hold
function stops and the last value is held
when the flag goes OFF.
1 HD1 Hold Flag for
Input CH1 The hold function is performed for Analog
Input CH1 while this flag is ON. The hold
function stops and the last value is held
when the flag goes OFF.
2 HD2 Hold Flag for
Input CH2 The hold function is performed for Analog
Input CH2 while this flag is ON. The hold
function stops and the last value is held
when the flag goes OFF.
3 HD3 Hold Flag for
Input CH3 The hold function is performed for Analog
Input CH3 while this flag is ON. The hold
function stops and the last value is held
when the flag goes OFF.